All Rights Reserved. This shower set has been made with premium-grade lightweight and the LED lights will automatically light up and set the mood. They will even change colors automatically based on the water temperature. All this with no batteries, everything is self-powered by a built-in dynamo that takes advantage of the water pressure to create the energy to light the bulbs. The flow rate is 2.
Observe all local building and safety codes. Unpack and inspect the product for any shipping damages. If you find damages, do not install. Please note all showers must be installed by a professional and certified plumber otherwise warranty might be voided. Step According to the dimensions and shape of the mounting bracket, determine the bracket location to be installed in the ceiling.
According to the 8 mounting holes on the mounting bracket, use an Electric drill to make the mounting holes. Shower Head Installation Instructions.
Using the two hexagonal nuts adjust the distance between the mounting bracket and the ceiling, and keep the mounting bracket on the level. Use an explosion screw to fix the mounting bracket on the ceiling, pay attention to the explosion screw, it can adjust the height and use level tool to adjust the mounting bracket to reach level. Connecting Circuits. According to the chart shows: Raise the showerhead, Aim at the hole of the bolt, plug the bolt.
Use a Phillips screwdriver screw out the upper cover 4 screws, open the plastic waterproof boxes. Note: The same color line docking, brown line for line, the blue line is zero line. Use a Phillips screwdriver screw out the screws in plastic waterproof box wiring position, then put the fork terminal line connected, then fix it with a Phillips screwdriver.
According to the circuit diagram as shown in step 5, then connect plastic waterproof case, please note that the same color of the wire when connecting circuit to docking. Connecting water hoses and Tee joints and then connect the water hoses to the water inlet pipe connector. Installing the shower body by plugging the bolts.
As the above picture. Install the decorative panel and twist the corresponding 8 fixing screws with a SW4 hex wrench. Install 4 LED lights and lamp cups clockwise. Note: 1. Before connecting water hoses and water pipes, cleaning the water pipes first. It will prevent impurities from clogging the showerhead. Connect 4 water inlet hoses to the wall-embedded water inlet pipes and then seal the wall.
HandHeld Shower. Hand Held Shower. Handheld Shower. Body Sprays. Step 5: Pressure Balancing Loop. Note: The hole size opening should be 1.
Bodyspray placement: Custom shower systems are sized to the user or users. Bodysprays are normally placed at the upper back, middle back, and upper thigh. Refer to the instructions included with the sink. The toggle bolts are installed to the back of the sink before it is set into place.
Since the bolts require a length long enough to allow the toggles to open inside of the wall, thread the winged toggles onto the bolts only a couple of turns. After the toggle bolts are in place, apply generous-sized dollops of silicone adhesive to the back of the sink.
The silicone adhesive provides additional strength and support for the pedestal sink. The pedestal base is set into place and aligned with the mounting holes drilled in the floor, when applicable. Set the sink on top of the pedestal, then slide the sink close enough to the wall so you can insert the winged toggles into the mounting holes in the wall, says Home Depot.
Verify the toggled wings open once you insert them into the wall by pulling on the bolt head. It should not pull out of the hole. Tighten the toggle bolts using a screwdriver or screw gun until they are snug. Use a screwdriver to tighten the screws an additional half turn. Remove any excess silicone that might have squeezed out from behind the sink with a rag and acetone.
Caulk or grout around the pedestal base to secure it to the floor. If the pedestal requires anchors, insert them into their respective holes, and tighten according to the manufacturer's instructions.
0コメント