At the end of the day, the filter you use will depend on the specific particles it will be filtering out on a daily basis. Factories that contain fine powder products, such as food and chemical industries, run the risk of handling combustible dust. To prevent such an issue from harming people and products in the vicinity, prioritize the installing of an explosion vent. An explosion vent, paired with a second flameless vent, will help mitigate any danger to people and products in the workplace.
This goes hand-in-hand with the previous step. Your ductwork should utilize either dampers or an isolation valve to minimize the risk of combustion.
A flow-activated passive inlet isolation valve will work with the explosion vent to, in the case of deflagration, suppress the explosion to hinder exterior damage. Many systems start off working well but then efficiency declines over time. You can alter the dimensions and couplings shown to fit different sizes or types of pipe. To mate the 3" or 4" system to most of your tools, you'll need hoses and adapters.
The best way to do this is with tapered not stepped transitions. Installing a Dust Collection System. How to set up your system. Pin FB More.
Dust Collection Illustration 2. Construct a central system So you've bought a dust collector. Fasten joints with screws rather than glue so you can open the system easily to dislodge jams. Run a 5"-6"-diameter line to your heaviest chip-producers—planer, jointer, etc. A 4" line will adequately serve saws, sanders, and the like. All rights reserved. I first attached a backer board to the wall, centered on a stud. At the top of the board, I installed the docking port with the included screws. Below that, I installed the hose straps, making sure they were level and centered on the board.
I attached tool ports to my drum sander, belt sander, joiner and bandsaw. These allow the quick release handle to be easily moved from tool to tool. With all of the ports attached, I then moved my tools to their new locations.
I built mobile bases for my drum sander, bandsaw and joiner to allow ease of movement when using the tools. They are also set up in a much better way to allow for increased productivity when moving from tool to tool. This corner of my shop is now so much cleaner and more efficient with the layout. The quick change shop and tool set also comes with spring clamps that I installed on the wall.
These keep the floor sweep and bench nozzle up and out of the when when not in use. I used to dread using my large tools because hooking them up to dust collection was difficult. My new quick change handle makes the job so much easier. The floor sweep and bench nozzle make cleaning a breeze. Special thanks to Rockler Woodworking and Hardware for partnering with me on this project. They will answer any questions for you and will also have helpful suggestions on the best way to go about doing it.
Like I said before, my plan was far more complex than it needed to be. I am so glad I contacted the support team and they lead me in a much better direction! Your email address will not be published.
0コメント